Table of Contents
Advertisement
EN
1.5. Intended use
The DRYPOINT
M eco control drying system with integrated nanofilter and pressure dew point control is designed for the
®
removal of aerosols and particles from compressed air and subsequent targeted drying of the air according to the individual
settings by the user.
Operate the DRYPOINT
M eco control only for the intended purpose and within the limit range specified in the technical
®
data. Do not operate the unit with any media (fluids, gas/vapour mixtures) other than those listed above. Any other use
of this system, which exceeds the intended use, is hereby deemed to be improper and can cause a hazard for the safety of
people and the environment.
•
Operating the unit may only be executed within the permissible operating parameter limits (refer to technical data).
•
Operating pressure will be required for the proper functional operation.
•
The device is not suitable for operation in explosion hazard areas as well as in areas with aggressive atmospheres.
•
Do not operate the device with corrosive gases.
•
Strictly observe the prescribed storage and transport conditions.
•
The device is not suitable for use in conjunction with CO
The operating company must establish measures for the monitoring of the compressed air quality when using industrial
processes with higher quality requirements (e.g. food industry, medical technology, laboratory equipment, special processes,
etc.). These influence the safety for subsequent processes and can prevent injuries to people and damage to plants and
systems. It is the duty of the owner and/or operator to always comply with the stated conditions during the entire operating
time.
1.6. Warranty and liability for defects
All liability claims will be deemed to be invalid when the DRYPOINT-M
intended use or is operated outside the specifications stated in the technical data, this particularly includes:
•
Technically incorrect installation, incorrect commissioning, incorrect maintenance or incorrect operation
•
Operation with defective components
•
Non-compliance with the instructions in this manual, in particular the safety instructions
•
Execution of constructive interventions or modifications on the device
•
Non-compliance with the prescribed maintenance intervals
•
Use of third-party spare parts that have not been approved by the manufacturer for repair and maintenance works
DRYPOINT
M eco control
®
systems.
²
eco control is not utilised in accordance with its
®
Installation and operation manual
7
Advertisement
Table of Contents
