EN
13. Place the switch-over valve seat into the control unit.
•
The seal points upward
•
The raster points downward
14. Pull the retaining plate with screws upward from the
pilot valve seat. Exchange the core guide pipe with core.
Insert the retaining plate with screws again into the pilot
valve seat.
15. Insert the pilot valve seat and screw connect the upper
screws.
16. Rotate the solenoid coil by 180 °, place and screw
connect with the knurled screw.
DRYPOINT
M eco control
®
Installation and operation manual
Ø = 2,5 mm
M = 0,5 Nm + 10 %
39