Prism Block Assembly - Sony PMW-300 Service Manual

2-20.

Prism Block Assembly

Preparation
1. Remove the bottom panel assembly. (Refer to
2. Remove the inside panel assembly. (Refer to
3. Remove the outside panel assembly. (Refer to
4. Remove the rear panel assembly. (Refer to
5. Remove the handle assembly. (Refer to
6. Remove the IO block. (Refer to
7. Remove the DCP-64 board. (Refer to
8. Remove the front lens assembly. (Refer to
9. Remove the lens unit. (Refer to
Procedure
1. Disconnect the three harnesses from the three connectors (CN100, CN101, and CN102) on the SE-1139 board.
2. Release the three harnesses and the three fine-wire coaxial cables from the three claws.
Fine-wire coaxial cable
Harnesses
CN101
Fine-wire coaxial cables
PMW-300
"2-5. Bottom Panel
"2-6-1. Inside Panel
"2-7-1. Outside Panel
"2-8. Rear Panel Assembly")
"2-11-1. Handle Assembly")
"2-10. IO Block")
"2-14. DCP-64 Board")
"2-15. Front Lens
"2-19. Lens Unit")
Claws
CN100
CN102
Assembly")
Assembly")
Assembly")
Assembly")
Harness
SE-1139 board
2-55