Table of Contents
Advertisement
2-11-5.
HN-411 Board
Preparation
1.
Remove the bottom panel assembly. (Refer to
2.
Remove the inside panel assembly. (Refer to
3.
Remove the outside panel assembly. (Refer to
4.
Remove the rear panel assembly. (Refer
5.
Remove the handle assembly. (Refer to
6.
Remove the handle U-case assembly. (Refer to
Procedure
1.
Remove the four screws to detach the rear shoe.
2.
Disconnect the two flexible flat cables from the two connectors (CN100, CN102) on the HN-411 board.
3.
Remove the two screws to detach the HN-411 board.
Flexible flat cable
4.
Install the removed parts by reversing the steps of removal.
PMW-300
"2-5. Bottom Panel
"2-6-1. Inside Panel
"2-7-1. Outside Panel
to"2-8. Rear Panel
"2-11-1. Handle
Assembly")
"2-11-2. Handle U-case
P2 x 4
P2 x 4
CN100
Assembly")
Assembly")
Assembly")
Assembly")
Assembly")
P2 x 4
Rear shoe
HN-411 board
CN102
Flexible flat cable
2-40
Advertisement
Table of Contents
