Input Connectors; Connections - Toa SR-F09 Operating Instructions Manual

6. INPUT CONNECTORS

• The figures below show each speaker's input configuration. Because the connector is internally connected in
parallel to the screw terminal, you can use either of the two.
[SR-F09]
• Pins of the Neutrik connector are connected as shown in the table below.
Pin No.
1 + Speaker +
1 − Speaker −
2 +
2 −
• The usable connector (on the cable end) for the NL4MPR connector is Neutrik's NL4FC.

7. CONNECTIONS

7.1. Combination with a Sub-woofer
Digital Processor*
INPUT
* For the digital processor settings, see p. 11.
7.2. Singular System of SR-F09
Digital Processor*
INPUT
* For the digital processor settings, see p. 11.
7.3. About the Power Amplifier to Connect
It is recommended that you use a power amplifier with output of over 400 W (per channel when an 8 Ω load is
connected).
[SR-L09]
SR-F09 SR-L09
-
-
-
Speaker +
-
Speaker −
Power amplifier
MAIN OUT
BASS OUT
Power amplifier
MAIN OUT
[SR-L05]
SR-L05
-
-
Speaker +
Speaker −
SR-F09
SR-L09, SR-L05
SR-F09
5