Table of Contents
Advertisement
CAUTION
9.1. USAGE
(Refer to Fig. 1.)
Step 1. Extend the stand's legs.
Loosen the tripod fixing screw and open the
tripod legs outward so that the stays become
level.
Step 2. Attach the stand bracket to the speaker
using the speaker mounting screws and plain
washers. (Fig. 2).
Step 3. Loosen the bracket fixing screw, then place
the speaker on the stand.
After setting the speaker's orientation,
retighten the bracket fixing screw.
Step 4. Adjust the stand height.
4-1. Loosen the height fixing screw.
4-2. Loosen the handle fixing screw and raise the
handle, then retighten the handle screw.
4-3. While holding down the lock button, adjust
the speaker's height by turning the height
adjustment handle. (Clockwise rotation raises
the speaker.)
Note
You cannot rotate the handle unless the lock
button is continuously pressed. To complete
the height adjustment, ensure that the shaft
is locked when the lock button is released.
(This can be checked by rotating the handle
slightly.)
Step 5. Retighten the height fixing screw.
Step 6. Loosen the handle fixing screw and replace
the handle by tilting it up, then retighten the
handle screw. Leave the handle tilted up
except when adjusting the height.
Step 7. After use, reverse the above procedures to
put away the stand.
• Only use the stand on the flat, hard ground or floor surfaces.
• Avoid installing the stand in the passage where people could trip over
the tripod legs.
• When using the stand outdoors, avoid locations exposed to strong
winds.
• To minimize the chance of the stand toppling over, avoid extending
the stand too high.
• When the stand could fall down, be sure to secure it with guy wires or
other devices.
(Fig. 1)
Bracket fixing screw
4
Height fixing screw
(Fig. 2)
* Prepare separately.
SR-F09
Stand bracket
195/8
Lock botton
5
-1,
1
Tripod fixing screw
Speaker stand
213
Stand bracket
Plain washer
(for M8)*
Speaker mounting screw
M8 x 20*
Plain washer (for M8):
Speaker mounting screw M8 x 20: 2 pcs
3
4
-3
Handle fixing screw
4
6
-2,
Height adjustment handle
Height adjuster
Tripod leg
Stay
2
2 pcs
7
Advertisement
Table of Contents
