Oil Details; Hyspin ® Vg 32 And Aws 32 Oil Safety Data; Priming Pump - Stanley Genesis 07537 Original Instructions Manual

P r im in g
Priming is ALWAYS necessary after the tool has been dismantled and prior to operating. It may also be necessary to restore the full stroke after
considerable use, when the stroke may be re duced and fasteners are not fully placed by one op er a tion of the trigger.
Oil Deta ils
The recommended oil for priming is Hyspin
Please find specific table and safety data below.
®
Hyspin VG 3 2 and A WS Oil S afety Da ta
First Aid
SKIN:
Wash thoroughly with soap and water as soon as possible. Casual contact requires no immediate attention. Short term contact requires no immediate
attention.
INGESTION:
Seek medical attention immediately. DO NOT induce vomiting.
EYES:
Irrigate immediately with water for several minutes. Although NOT a primary irritant, minor irritation may occur following contact.
Fire
Flash point: 232°C. Not classified as flammable.
Suitable extinguishing media: CO
Environment
WASTE DISPOSAL: Through authorised contractor to a licensed site. May be incinerated. Used product may be sent for reclamation.
SPILLAGE: Prevent entry into drains, sewers and water courses. Soak up with absorbent material.
Handling
Wear eye protection, impervious gloves (e.g. of PVC) and a plastic apron. Use in well ventilated area.
Storage
No special precautions.
P riming Pump
To enable you to follow the priming procedure opposite, you will need to obtain a priming pump 07900-00700.
28
®
VG 32 available in 0.5l (part number 07992-00002) or one gallon containers (part number 07992-00006).
, dry powder, foam or water fog. DO NOT use water jets.
2