Servicing The Tool; Daily; Weekly; Molylithium Grease Ep 3753 Safety Data - Stanley Genesis 07537 Original Instructions Manual

S e r v i c i n g th e To o l
Regular servicing should be carried out and a comprehensive inspection performed annually or every 500,000 cycles, whichever is sooner.
The employer is responsible for ensuring that tool maintenance instructions are given to the ap pro pri ate personnel.
The operator should not be involved in main te nance or repair of the tool unless prop er ly trained.
D aily
•
Daily, before use or when first putting the tool into service. Pour a few drops of clean lubricating oil into the air inlet of the tool if no lubricator is
fitted on air supply. If the tool is in continuous use, the air hose should be disconnected from the main air supply and the tool lubricated every two
to three hours.
•
Check for air and oil leaks. If damaged, hoses and couplings should be replaced.
•
If there is no filter on the pressure regulator, bleed the airline to clear it of accumulated dirt or water before connecting the air hose to the
intensifier. If there is a filter, drain it.
•
Check that the nose equipment is correct.
•
Check mandrels regularly for signs of wear or damage monitoring the number of placings (read the safety instructions on page 4).
•
Check the base cover is fully tightened onto the body.
W eekly
•
Conduct the full "Daily" procedures as described above.
•
Remove, inspect, clean and grease the Tail Jaws (refer to "Tail Jaw Cylinder" in the „Maintenance Section" page 24).
Mo lyLithi um Gre as e EP 3753 Safe t y Da ta
Grease can be ordered as a single item, the part number is shown in the Service Kits page 23.
First Aid
SKIN:
As the grease is completely water resistant it is best removed with an approved emulsifying skin cleaner.
INGESTION:
Ensure the individual drinks 30ml Milk of Mag ne sia, preferably in a cup of milk.
EYES:
Irritant but not harmful. Irrigate with water and seek medical attention.
Fire
FLASH POINT: Above 220°C.
Not classified as flammable.
,
Suitable extinguishing media: CO
2
Environment
Scrape up for burning or disposal on approved site.
Handling
Use barrier cream or oil resistant gloves
Storage
Away from heat and oxidising agent.
I M P O R T A N T
Halon or water spray if applied by an experienced operator.
21