Loading The Tool; Reloading The Tool; Operating Procedure - Stanley Genesis 07537 Original Instructions Manual

P u t ti n g i nt o Se r v i ce
L oa ding the T ool
•
Connect the air supply to the tool.
•
Open tail jaws 34 which grip the mandrel, by switching off the tail jaw switch (items 22 and 23).
•
Screw selected nose jaws onto barrel 44 of the tool.
•*
Insert a mandrel into the tail end of the fasteners through the paper pod.
•
Slide the mandrel follower spring onto the mandrel ensuring correct orientation, as shown in the table on page 11.
•
Gripping the tail end of the mandrel, tear off the paper pod from around the fasteners.
•
Open the nose jaws either by rotating the outer ring on Cam operated jaws or by pushing outwards on the jaw ends, as illustrated below left.
•
Insert the previously assembled mandrel, mandrel follower spring and fasteners into the nose jaws until the first fastener to be placed is protruding
from the nose jaw.
•
Close the nose jaws and adjust so that the first fastener protrudes by 1.5mm - 3mm (
•
Close the tail jaws to ensure the mandrel is gripped, by switching on the tail jaw switch (items 22 and 23).
Relo ading the T ool
•
Open tail jaws 34 of tool.
•
Open the nose jaws and pull the empty mandrel and mandrel follower spring out of the tool.
•
Reload the tool by following the above instructions, starting at stage
Operati ng Pro ce dur e
You must check that the cursor orientation and the nose equipment are correct before at tempt ing to operate the tool.
•
Push the fastener, protruding from the nose jaws, fully into the application holes ensuring that the tool is held square.
•
Operate the trigger without releasing - the mandrel head is pulled through the fastener, forming the fastener into the application.
•
Remove the tool.
•
Release the trigger. The next fastener will be automatically presented through the nose jaws, ready for placing.
Item numbers in bold refer to the general assembly and parts list for the 07537-00200 on pages 26-27.
10
1 / " to 1 / "), as shown in the il lus tra tion below right.
16 8
•*
.
IMPORTANT
1.5mm - 3mm
1 1
( " - ")
/16 /8