Configuring The System Via Rs-485 Loop - Honeywell NetAXS-123 User Manual

20 |
NetAXS-123 Access Control Unit User's Guide
You have now finished creating an Ethernet Virtual Loop.

Configuring the System Via RS-485 Loop

By default, the Loop Mode is set to RS-485. If it was set EVL and the user set it back to
RS-485, the panel will automatically reboot. Panels in a RS-485 loop are wired together in
daisy chain fashion. Up to 31 controllers may be wired together in a RS-485 loop; that is
one primary and up to 30 secondary controllers.
IMPORTANT: Only 1 Primary controller may be in a RS-485 loop. All of the Secondary
controllers must have DIP switch 6 set to the OFF position.
1.
See
www.honeywell.com/security
b. Click REGISTER to register a panel. The REGISTER buttons changes to
UNREGISTER when the registration is successful.
Figure 2-5 Registered Secondary Controllers
Log into NetAXS-123 Primary panel from a browser through Ethernet (default
192.168.1.150), or USB (192.168.2.150).
Setting Up the USB Connection on page 6. See Setting Up an Ethernet Port on page 8.