Option; Installation - Runco Reflection CL-610 CineWide Owner's Operating Manual

Operation

Installation

Installation
Language
Picture Orientation
Keystone Adjust
Background Color
RS-232 Baud Rate
Blue Image

Option

Option
Reset Image Settings
Sleep Timer
Lamp Hours
OSD Timer
OSD Position
PC & HD Adjust
PIP/PBP Set Up
DNR
To access the Installation adjustments, press MENU, then press the
highlight Installation and press ENTER. The Installation sub-menu, shown at left, appears.
Press EXIT to return to the previous menu or press MENU to close all menus.
When you change a setting in the Installation menu, the change
Note
takes effect immediately; you do not need to press ENTER
afterwards. (Press EXIT to return to the previous menu or MENU
to exit.)
Language: Press the
French, Spanish, German and Italian.
Picture Orientation: Press the
image. The CL-610 can be installed on a ceiling or in a rear-screen configuration with one
or more mirrors. There are four settings: Floor Front, Ceiling Front, Floor Rear and Ceiling
Rear.
Keystone Adjust: To correct distortion resulting from the angle of projection, select
Keystone Adjust and use the
Runco recommends that the keystone feature not be used unless
Tip
absolutely necessary, as it may cause artifacts in the image.
Background Color: Press the
(blue or white). The Background Color appears when no incoming signal is present.
RS-232 Baud Rate: Press the
Rate. This function is used to change the transfer rate of the RS-232 connection. (This
setting must match the data rate of the device connected to the RS-232 input.)
Blue Image: Press the
removes all red and green color information from the image (simulating a blue filter), and is
useful for color-calibrating the projector or other video components.
To access the Option adjustments, press MENU, then press the
highlight Option and press ENTER. The Installation sub-menu will then appear (see
above). Press EXIT to return to the previous menu or press MENU to close all menus.
Reset Image Settings: To restore the default image settings for the current input source
ONLY, press the button to highlight "Yes," then press ENTER.
Sleep Timer: The Sleep Timer automatically puts the projector into standby mode after
the amount of time you specify here. (A warning appears on-screen one minute before this
is to occur.)
Use the or button to set the timer for anywhere from 10 minutes to 3 hours, in
10-minute increments. To disable the Sleep Timer, set it to 0.
Lamp Hours: To find out how long the projector lamp has been in use, select Lamp
Hours and press ENTER.
OSD Timer: Use the
the menus remain on-screen after selecting them. Select from 0 to 60 seconds, in
3-second increments. When you set the OSD to 0, the menus remain on-screen until you
hide them by pressing MENU.
or button to select from the available languages: English,
or button to change the orientation of the projected
or button to make the image rectangular.
or button to select the image Background Color
or button to select the projector's RS-232 Baud
or button to turn the Blue Image Off or On. This feature
or button to set the OSD Timer. This timer controls how long
40 Runco CL-610 Series Owner's Operating Manual
or button to
or button to