Option - Runco Reflection CL-610LT Owner's Operating Manual

Runco CL-610
> Video
S-Video
Component1
Component2
RGB-HD
HDMI
------------------------
Aspect Ratio
Installation

Option

Setup
ISF Calibration
To access the Option adjustments, press Menu, then press the ▲ or ▼ arrows to
highlight Option and press Enter. The Option sub-menu will then appear (see above).
Press the Exit button to return to the previous menu or press the Menu button to
close all menus.
To restore the default image settings for the current input
source ONLY, press the ► arrow key to highlight "Yes" then
press Enter.
The Sleep Timer automatically puts the projector into standby
mode after the amount of time you specify here. (A warning
appears on-screen one minute before this is to occur.)
Press the ◄ or ► arrows to set the timer for anywhere from
10 minutes to 3 hours, in 10-minute increments. To disable
the Sleep Timer, set it to 0.
Press the Enter button to check the total time of lamp
usage.
Press the ◄ or ► arrows to set the OSD Timer. This
timer controls how long the menus remain on-screen after
selecting them. Select from 0 to 60 seconds, in 3-second
increments. When you set the OSD to 0, the menus remain
on-screen until you hide them by pressing Menu.
Press the ◄ or ► arrows to adjust the horizontal and vertical
position of the OSD.
Runco CL-610 Owner's Operating Manual
Option
Reset Image Settings
Sleep Timer
Lamp Hours
OSD Timer
OSD Position
PC & HD Adjust
PIP/PBP Set Up
DNR
Reset Image Settings
Load default of
current source
Confirm?
No Yes
Sleep Timer
- 0 + Minutes
Lamp Hours
+8 Hours
+30 Minutes
OSD Timer
+60 -
OSD Position
0
Hor.
Ver. +20
37
On-Screen Display Menus
Option
➤ Reset Image Settings
➤ Sleep Timer
➤ Lamp Hours
➤ OSD Timer
+
➤ OSD Position