Runco Reflection CL-610 CineWide Owner's Operating Manual page 57

Reset Lamp Timer: When you replace the projector lamp (refer to Lamp Replacement
on page 49), you should also reset the lamp timer. To do this, select Reset Lamp Timer
from the Set Up menu. Press the right-arrow key on the remote to highlight "Yes," then
press ENTER to confirm the reset.
Reset the Lamp Timer ONLY after you replace the lamp. Otherwise,
Note
the reported "Lamp Hours" will be inaccurate.
Do not exceed the recommended lamp life of 2000 hours. An old
WARNING
lamp becomes increasingly fragile and prone to sudden failure.
Fan Control: Select Fan Control from the Set Up Menu to control the operation of the
projector's cooling fan.
• Mode: In most cases, the default Fan Control Mode (Auto Normal) will maintain the
correct operating temperature. If the lamp frequently turns off due to overheating, or in
certain high-altitude operating environments, you may need to change this setting to
Auto Hi. Altitude or Manual.
• Fan Speed: If you set the Fan Mode to Manual, select Fan Speed and use the
on-screen slidebar to adjust the speed.
After changing either of these settings, press EXIT to return to the previous menu.
Return to User OSD: To exit the Set Up menu, use the up- or down-arrow keys to
highlight Return to User OSD and press ENTER.
To return to the Set Up menu, select it from the Main Menu, press ENTER twice, then
press MENU on the remote control. (You do not need to re-enter the passcode.)
Runco CL-610 Series Owner's Operating Manual 45
Operation