SPEC
CABLE ROUTING
GG Clamp the throttle position sensor lead with the
coolant reservoir tank hose in front of the coupler.
Point the tip of clamp to the downward.
HH Place the white mark on the coolant reservoir
tank hose within the range of ±20 mm to the
clamp position along the axial direction of hose.
II
Position the fitting part of clamp lower than the
centerline of frame.
JJ Push in the ignition coil lead between the cross
a
pipe and ignition coil under this line
.
KK Route the wire harness beneath the rectifier / reg-
ulator.
–13–