Yamaha FZS1000 2003 Supplementary Service Manual page 19

A Route the throttle cables through right side of the ra-
diator fan motor lead and thermo switch lead.
and EXUP motor lead
B Clamp the right turn signal lead (front).
C Route the all leads through between frame cross
pipe and bracket.
D Route the coolant reservoir tank hose through un-
der the cross pipe.
E Do not excessively bend the throttle cable.
F Fasten the ignition coil and ignition coil lead with a
plastic band and end of the plastic band downward.
G Route the throttle position sensor lead through un-
der the air vent hose.
H It is allowed to select either color for leads. Point the
lead toward the inner side.
I Clamp the EXUP cable with a plastic clamp and
clamp open end upward.
CABLE ROUTING
J Route the coolant reservoir tank hose through un-
der the air vent hose and AI system hose.
K Route the coolant reservoir tank hose through un-
der the frame cross pipe.
L Clamp the fuel hose with a plastic clamp.
M Put the fuel tank breather hose into the forward nip-
ple on the fuel tank.
N Put the fuel tank breather hose into the backward
nipple on the fuel tank.
O Insert the positioning clamp of wire harness to the
T-stud of frame.
P Fasten the fuel hose and AI system hose with a
plastic band and end of band downward.
Q Put air vent hoses (left and right) into air filter case
groove.
R Route the air vent hose through over the wire har-
ness.
–11–
SPEC