Yamaha FZS1000 2003 Supplementary Service Manual page 20

S Route the rectifier / regulator lead through under the
wire harness.
T Place the coupler of each lead in the coupler cover.
U Clamp the wire harness and rectifier / regulator lead
with a clamp.
V Attach the ignition coil lead and clamp it with the
frame cross pipe at the right side of bracket. Howev-
er, do not clamp a bare lead.
W Route the rectifier / regulator lead through over the
radiator fan motor lead and EXUP motor lead.
X Clamp the left and right handlebar switch leads,
main switch lead, EXUP motor lead, radiator fan
motor lead and thermo switch lead with a plastic
clamp.
There should be no interference of each lead with
the throttle cable and spark plug leads.
CABLE ROUTING
Y Clamp the stay, wire harness and rectifier / regulator
leads. Cut the surplus part of clamp. Leave the re-
mained part to be within 3 mm after cutting.
Z Clamp the left turn signal lead and headlight sub-
wire harness.
AA Clamp the battery negative lead with a battery
band.
BB Insert the coupler of negative lead to the hole of
battery band.
CC To the turn signal light.
DD Fasten the tail / brake light lead and turn signal
light lead, and put in the groove on the tail / brake
light bracket.
EE Put the lock cable into the groove on the rear
fender.
FF Fasten the battery positive lead to the frame with
a plastic clamp.
–12–
SPEC