Electrical Connections To Awning - Dometic 9100 Installaiton Instructions

INSTALL AWNING
rivets.
Alternatively, structural screws (installer
supplied) may be used to secure back
channel if RV has structural backing that
will support at least 100 lb force per screw.
FIG. 18
9. Repeat steps (1) through (8) for opposite side.
10. Apply sealant to #14 - 10 x 1-1/2" hex head screw
threads. Then place and tighten screws through
remaining slots of both top mounting brackets
and into solid structure of RV. See (FIG. 14) &
(FIG. 15).
D.

Electrical Connections To Awning

 Failure to obey the following notices
could damage product or property:
● Make sure the positive (+) 12 Vdc terminal is
disconnected from supply battery. Otherwise,
damage to unit could occur.
● ALWAYS seal wiring against weather and mois-
ture where wiring enters the RV's walls, roof , or
floor. Otherwise, water leakage could occur.
● Do NOT pinch wiring or allow wiring to rub against
sharp edges. If wiring is damaged, it MUST be
replaced by a qualified service technician.
Use a grommet (installer supplied) when routing
wiring through RV wall.
 I f grommet is NOT used, use heat-shrink tub-
ing where wiring will pass through RV wall.
1. MOTOR AND SWITCH CONNECTIONS:
a.  P ull wiring through wiring hole (and grom-
met), and connect to appropriate wiring in-
side RV.
 I f grommet is NOT used, make sure
sealant will also provide effective and
permanent protection against wire
damage.
See instructions included with your
Dometic Corporation switch kit for ad-
Back Channel
3/16" x 1"
Oscar Rivet
b. Connect motor wiring to the factory pre-
wired hardware wiring (near RH end cap).
See (FIG. 19).
c. Secure any slack motor / hardware wiring
inside front channel to prevent pinched or
damaged wiring during awning operation.
FIG. 19
2. POWER TRACK CONNECTIONS:
 P ower track wiring includes track and LED
strip.
a.  P ull wiring through wiring hole (and grom-
met), and connect to appropriate wiring in-
side RV.
b. Connect power track / LED wiring to the fac-
tory pre-wired hardware wiring (near LH end
cap). See (FIG. 20).
c. Secure any slack power track / hardware wir-
ing inside front channel to prevent pinched
or damaged wiring during awning operation.
12
ditional wiring instructions.
RH End Cap
Motor Wiring
Hardware Wiring
 I f grommet is NOT used, make sure
sealant will also provide effective and
permanent protection against wire
damage.
See instructions included with your
Dometic Corporation switch kit for ad-
ditional wiring instructions.