Secure Awning Fabric To Awning Rail; Verify Installation; Test Operation; Secure Awning For Travel - Dometic 9100 Installaiton Instructions

INSTALL AWNING
F.

Secure Awning Fabric To Awning Rail

1.  W ith power applied to awning, open and close
awning four or five times to allow natural self
adjustment of awning fabric. See Operating In-
structions.
2. Verify alignment of awning fabric, and proper
nesting of hardware.
a. If there is misalignment, adjust arm assembly
by loosening back channel and top mounting
bracket screws and move back channel ac-
cordingly. (Retighten screws.)
b. Cycle awning again to check alignment.
3. Ensure arm assemblies are still nested correct-
ly, then mark location of awning fabric edges on
awning rail.
4. Pull one edge of awning fabric approximately
1/4" beyond marked position. Then secure with
#6 x 7/16" TEK screw through awning rail (ap-
proximately 2" from fabric edge). See (FIG. 21)

VERIFY INSTALLATION

A.

Test Operation

With power applied to awning, operate awning ac-
cording to Operating Instructions to verify all parts
are functioning correctly.
B.

Secure Awning For Travel

1.  F ully close awning. See "Close Awning" in Oper-
ating Instructions.
2. Verify awning is secure for travel. See "Prepare
Awning For Travel" in Operating Instructions.
FIG. 21
5. Pull to stretch opposite edge of awning fabric
approximately 3/4". Then secure with #6 x 7/16"
TEK screw through awning rail (approximately
2" from fabric edge).
C.

Keep Literature

Instructions contain valuable information for prod-
uct use and consumer safety.

Keep BOTH the Installation and OperatIn-
stall Awning
14
#6 x 7/16"
TEK Screw
Awning Rail
2"
Fabric Edge