Remote Control - Arcam SA10 Handbook

Remote Control

CD
DISP INFO
MODE
OK
AMP
BAL BAL
CD BD
PHONO
The remote control is pre-programmed for use with the
SA10/SA20 amplifier and also an Arcam CD player. The
information in this section applies to the AMP section
of the remote control only.
Make sure the two AAA batteries (supplied) are installed
before attempting to use the remote control.
1. With the remote face down, press down on the non-
slip indentations of the battery compartment cover
and slide the cover off
NOTE: The supplied remote control is designed to support both the SA10/SA20 integrated amplifier as well as an
Arcam CD player. The section below applies to the AMP section of the remote control only. Refer to the CD user
manual for description on the CD section of the remote control unit.
Toggles power between standby and
powered on
Cycles through the front panel display
brightness options
Toggles the mute function of the amplifier
Increase/decrease amplifier volume
Adjust the balance of the left channel
BAL
Adjust the balance of the right channel
BAL
2. Insert the two AAA batteries (supplied). Take care to
insert the batteries in the right direction by following
the '+' and '-' marks in the battery compartment
3. Slide the battery compartment cover back and lock
it in place with a click
The remote control requires a clear line of sight to
the front panel of the SA10/SA20 to ensure reliable
operation.
Select the PHONO (MM) input
PHONO
Select the CD analogue input
CD
Select the BD coaxial digital input
BD
Select the SAT optical digital input
SAT
Select the PVR analogue input
PVR
Select the AV coaxial digital input
AV
Select the 3.5mm socket analogue input
AUX
(located on the front panel)
Select the STB analogue input
STB
EN-13
EN