Using The Remote Control; Cr-389 Remote Control - Arcam A85 Handbook

Using the remote control

CR-389 Remote Control

The CR-389 remote control gives access to all functions
available on the front panel of the A85. It also has controls
to operate Arcam CD players, AM/FM tuners and DAB
tuners. The remote control transmits Philips RC-5 type
codes.
These buttons are used to control tuner functions.
Note that the FM/DAB lights indicate into which mode
you are switching the remote control. The lights only
illuminate for fi ve seconds to conserve battery power.
If neither light is illuminated this does not mean that the
remote control is not working!
Perform the same function as the
buttons on the front panel (see page 6).
Performs the same function as the
button on the front panel (see page 8).
Performs same function as the SELECT
panel. It allows you to use the remote's volume switch in the
same way you use the control dial on the front panel – to
adjust various amplifi er settings (see page 8).
Note that pressing + corresponds to turning the
Control knob clockwise, – to anticlockwise.
Source selection buttons
These operate in the same way as the source selectors
on the front panel of your integrated amplifi er.
NOTE: Remember to install the two supplied AAA batteries
before trying to use your remote control!
Do not place anything in front of the IR receiver on the left
of the A85, or the remote control may not work.
A85/P85 multi.id
TUNER
TUNER
FM DAB
FM
MENU
DAB
1- 9 2- 1 0
(UP and DOWN)
5- 1 3 6- 1 4
MODE
ENTER
ENTER
ENTER
SEL
SELECT
button on the front
PHONO AUX
A V DVD
AMPLIFIER
CD
CR-389
9
Power/Standby
Toggles the amplifi er between standby mode and full power
mode. The power indicator light next to the power button on
DISP
the front panel is red if the amplifi er is in standby, amber while
the amplifi er is powering up (this only takes a few seconds) and
3- 1 1 4- 1 2
green when the amplifi er is powered up.
7- 1 5 8- 1 6
BAND SP1 and SP2
These buttons allow you to select and deselect the main
(SP1) and secondary (SP2) sets of speakers attached to your
SP1
amplifi er (see page 6).
SP2
DISP
DISP (display)
Cycles through the settings 'Bright', 'Off' and 'Dim'. Turning
the display 'Off' generally gives a slight improvement in sound
quality.
Volume and (mute)
Press + to increase volume or
of the amplifi er.
CD TUNER
Press to mute the speaker connections and preamp outputs.
Both tape outputs and the headphone socket remain active.
VCR TAPE
Mute is disabled either by pressing
the volume.
You can use the remote's volume control in conjunction with the
SELECT button to adjust balance, tone and amplifi er settings.
RPT
PROG DISP
CD controls
These offer basic controls of Arcam CD players
– to decrease the output volume
again, or by adjusting
A85/P85
9
03/29/01, 3:42 PM