Advertisement
3
Opening & closing of sensor
OPENING
4
Installation tips
Avoid vibrations!
5
Troubleshooting
SYMPTOMS
The door will not open and LED is OFF.
The door opens and closes constantly.
The door will not close.
LED is OFF.
6
Technical specifications
Technology
Transmitter frequency
Transmitter radiated power
Transmitter power density
Maximum mounting height
Tilt angles
Max. detection field (mounting height=2.2m)
Detection mode
Minimum speed
Supply voltage
Mains frequency
Power consumption
Output relay (free of potential change-over contact)
Max. contact voltage
Max. contact current
Max. switching power
Output hold time
Temperature range
Degree of protection
Material
Color of housing
Dimensions
Weight
Length of cable
Liege Science Park – Allée des Noisetiers 5, Angleur – BELGIUM – TEL +32.4.361.6565 – FAX +32.4.3612858 – E-mail: info@bea.be – www.beasensors.com
Do not cover the sensor!
Avoid moving objects
close to the sensor!
PROBABLE CAUSES
The sensor power is off.
1. The sensor "sees" the door moving. Increase the tilt angle and/or reduce the sensitivity.
2. When closing, the door creates
vibrations picked up by the sensor.
ON-OFF switch at door control is in
wrong position or faulty.
: microwave and microprocessor
: 24.125 GHz
: <20 dBm EIRP
: < 5mW/cm²
: 3m
: 25°, 30°, 35°, 40°
: 4m (W) x 2 m (D)
: motion
: 5 cm/s (measured in the sensor axis)
: 12V to 24V AC +/- 10%; 12V to 30V DC
: 50 to 60 Hz
: < 2W (VA)
: 42V AC- 60V DC
: 1A (resistive)
: 30W (DC) / 60VA (AC)
: 0.5s
: -20°C to +55°C
: IP52
: ABS
: black, aluminium finish
: 142mm (W) x 46mm (H) x 45mm (D)
: 0.100 kg
: 2.5m
CLOSING
Avoid HF lamps or
fluorescent lighting
close to the sensor!
CORRECTIVE ACTION
Check the wiring and the power supply.
Make sure that the sensor is correctly fixed.
Increase the tilt angle and/or reduce the sensitivity.
Make sure that the ON-OFF switch for the door is in the ON or
AUTOMATIC position.
Avoid touching
the antenna!
2/2
Advertisement
