Configuring
6.1 Configuring the CPU
6.1
Configuring the CPU
Requirements for configuration of the CPU
Table 6- 1
Requirements for installation
Configuration software
STEP 7(TIA Portal) as of V12.0
The following CPUs can configured as of V12: CPU 1511-1 PN, CPU 1513-1 PN, CPU 1516-3 PN/DP
1)
Please note that all other CPUs can be configured only as of a later version (e.g., as of V12 SP1). Refer to the product
manual for the CPU to find out whether the version of the CPU you are using is configurable in STEP 7.
6.1.1
Reading out the configuration
Introduction
When a connection exists to a physically present CPU, you can load the configuration of this
CPU (including centrally present modules) from the device into your project using the
"Hardware detection" function. You do not need to manually configure the CPU and the
centrally present modules, as the physical configuration is read out automatically.
If a CPU and the centrally present modules have already been configured and you want to
load the current configuration and parameters in a new project, it is advisable to use the
"Upload device as new station" function. For more information about this function, refer to
the chapter "Upload device as new station (Page 99)".
80
1)
Installation information
STEP 7 online help
System Manual, 12/2014, A5E03461182-AC
Automation system