Agency Compliance; Wireless Display Sensor (Wds) - Trane UniTrane Installation, Operation And Maintenance Manual

Agency Compliance

Table 41. Agency compliance information for wireless sensors
Agency Compliance
UL listed: UL 94-5VA Flammability rating
UL 916: Energy management equipment
FCC CFR47, Section 15.247 & Subpart E Digital Modulation Transmission with no SAR (FCC Identification TFP-
13651127)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1.
2.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
20 cm separation distance:
United States
To comply with FCC's RF exposure limits for general population/uncontrolled exposure, the antenna(s) used for this
compliance
transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be
(all models)
co-located or operating in conjunction with any other antenna or transmitter.
CSA22.2 No. 205-M1983 Signal Equipment
Industry Canada (Certification no: IC: 6178A-13651127)
Industry Canada statement:
the term "IC" before the certification/registration number signifies only that the Industry Canada technical
specifications were met.
Section 14 of RSS-210:
Canada compliance
The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emit
(all models)
RF field in excess of Health Canada limits for the general population.
IEEE compliance for
IEEE 802.15.4-2003, IEEE Standard for Information Technology—Telecommunications and information exchange
radio frequency range between systems—Local and metropolitan area networks—Specific requirements, Part 15.4: Wireless Medium Access
Control (MAC) and Physical Layer (PHY) Specifications for Low Rate Wireless Personal Area Networks (LR-WPANs)
(all models)

Wireless Display Sensor (WDS)

Configuration Procedure
Note: Sensors shipped with the fan coil are pre-
configured for three speeds.
The configuration of the sensor determines which system
features can be accessed and changes can be made by the
tenant (for example, changes to cooling/heating mode,
setpoint, or fan speed. Verify system and associated unit
features before configuring the sensor.
The building owner or operator may choose to limit tenant
access to certain features. This can be done through
configuration. Or, if a sensor is configured to match all
control capabilities of the building automation system, the
locking feature can be used to restrict the tenant from
making changes.
To configure settings on the wireless display sensor
(WDS), follow this procedure in the order presented.
1. Press the configuration button for three seconds.
UNT-SVX07J-EN
This device may not cause harmful interference, and
This device must accept any interference received,
including interference that may cause undesired operation.
Figure 91. Configuration button
The display will change to configuration mode. When the
sensor is in configuration mode, a wrench symbol appears
on the display and the menus are separated by lines, as
shown in the figure below.
Figure 92. Wrench is shown in configuration mode
Zone Sensor Options
Configuration
button
Wrench
99