Error Codes - Trane UniTrane Installation, Operation And Maintenance Manual

Zone Sensor Options
Changing Room Temperature
This symbol shows
the current room
temperature, or
your setpoint
.
selection while you
are making an
adjustment.
When you select a
setpoint, this
symbol appears.
Changing Heating/Cooling Settings
(does not apply to all systems)
Some systems allow
you to select both
heating and cooling
room temperature
settings. If your
system has this
option, this symbol
appears when you
adjust the
temperature setting.
When you adjust the
cooling setting, the top
arrow and snowflake
flash.
When you adjust the
heating setting, the
bottom arrow and
flame flash.
Changing Fan Settings
Indicates that the
fan will operate as
needed to reach
Fan Menu
the selected
temperature.
Indicates that the
fan setting is On.
The number of
arrows indicates
fan speed
(3: high, 2:
medium, 1: low).
The example
shown indicates a
fan on high speed.
Not all systems
offer all three
speeds.
Indicates that the
fan setting is Off.
102
1. To increase the room
temperature, press
To decrease the room
temperature, press
2. To confirm, press
wait 5 seconds. The
display will return to the
home screen.
1. Press or
select the heating/
cooling setting.
2. If in cooling mode, press
to change to heating
mode. If in heating
mode, press to
change to cooling
mode.
3. Press or
select the heating/
cooling setting.
4. To confirm, press
or wait 5 seconds.
The home screen will
appear.
1. From the home screen,
activate the fan setting
menu by pressing
and then .
2. Press or to choose
the desired fan setting.
3. When the symbol for the
desired setting appears,
confirm your choice by
pressing (the
home screen will
appear).
Requesting Temporary Occupancy
•
Select to
request
.
occupancy
.
or
Select to
cancel
•
occupancy
to

Error Codes

Indicates an
error code
Lock Symbol
to
Indicates
that a setting
is locked
Testing Signal Strength
Indicates
excellent
signal
strength
Press the Test button to display the signal strength
symbols.
Testing Battery Status
Indicates full
battery power
Press the Test button to display the battery status symbols.
Use only UL-listed non-rechargeable 1.5 V lithium AA
batteries (Trane p/n X13770035010 or equivalent).
If you need heating or cooling after
normal business hours, you can
"request" temporary occupancy by
pressing or and holding it for
2 seconds. The occupied symbol
remains on the screen and the
unoccupied symbol disappears.
After 30 seconds, the unoccupied
symbol will re-appear.
To cancel temporary occupancy,
press and hold for 2 seconds. The
unoccupied symbol will remain on
the screen and the occupied symbol
will disappear. After 30 seconds, the
occupied symbol will re-appear.
If an error code (E0–E7) is displayed,
technical assistance may be required.
The lock symbol appears if you try to
adjust a setting that cannot be
changed.
Indicates
satisfacto
ry signal
strength
Indicates 50
percent of
battery life
left.
symbol indicates that
approximately 14 days
of operation remain.
UNT-SVX07J-EN
Indicate
s poor
signal
strength
Indicates 25
percent of
battery life left.
Replace
batteries.
Flashing