Peak/Limiter Indicator; Usb Indicator - Roland Edirol UA-25 Owner's Manual

Front and rear panel
fig.front
4.

Peak/Limiter indicator

This indicates whether the input signal is distorting or the limiter is operating.
Limiter switch
Limiter on
Limiter off
5.

USB indicator

This will light blue when the UA-25 is connected to your computer via a USB cable
and the computer has correctly detected the UA-25.
6.
Digital input switch
If you want to record the digital input, turn this on ( inward position).
This allows you to synchronize with an external digital device connected to the
digital input connector (16).
Digital input switch
On
Off
On and no digital device
is connected to the digital
input connector
* When the digital input switch is on, you will not hear the sound from the computer.
* When the digital input switch is on, the settings of the Direct Monitor section are ignored. In
other words, operating the direct monitor switch (8), STEREO/MONO select switch (9),
or direct monitor volume (10) will have no effect.
10
1
2
Status
The indicator will function as a limiter indicator. When the input signal
exceeds a certain level, the limiter will operate and the indicator will
light green.
The indicator will function as a peak indicator. Use the input sensitivity
knobs for each input jack to adjust the input level so that the peak indi-
cator does not light red.
Mode
Digital input mode
Analog input mode
LoopBack mode
3 4 5 8 9
6 7 10 11
Status
The input from the digital input
connector (16) is sent to the com-
puter.
The input from the combo input
jacks (1) is sent to the computer.
The audio signal that is output from
your computer via USB will pass
through the UA-25 and return to the
computer.
12
13