Roland Edirol PCR-300 Owner's Manual page 50

Settings (Edit mode)
Advanced editing 1, 2
Program Change Assign advanced editing 1 lets you specify an upper limit and lower limit for the program change message. Advanced editing 2 lets you transmit Bank LSB/LSB
settings along with the program change.
1.
Press the [EDIT] button so it's lit.
2.
Slightly move the controller to which you want to assign a program change message. If the controller is a button, press it.
The display will indicate the number of the controller you selected.
3.
Check the indication in the display, then press the [ENTER] button.
4.
Turn the VALUE knob to make "PC" appear.
5.
Press the [ENTER] button.
Advanced editing 1 —Specifying the value range—
6.
Turn the VALUE knob or press controller [A2 (1)] to select the
advanced editing "PC1" indication.
7.
Press the [ENTER] button.
8.
Enter the channel.
9.
Press the [ENTER] button.
10.
Specify the range of values.
(-> Specifying the value range (upper/lower limits) (p. 45))
50
Advanced editing 2 —Transmitting a bank select—
6.
Turn the VALUE knob or press controller [A3 (2)] to select the
advanced editing "PC2" indication.
7.
Press the [ENTER] button.
8.
Enter the channel.
9.
Press the [ENTER] button.
10.
Enter the bank select MSB (CC#00). Use the VALUE
knob or controllers [A1]–[A8] and [B1]–[B8] to specify
the desired MSB.
* The - - - portion shows the currently specified value.
11.
Press the [ENTER] button.
12.
Enter the bank select LSB (CC#32). Use the VALUE knob
or controllers [A1]–[A8] and [B1]–[B8] to specify the
desired LSB.
* The - - - portion shows the currently specified value.
13.
Press the [ENTER] button.
14.
Enter the program number.
15.
Press the [ENTER] button.
16.
Specify the output port. (-> Port setting (p. 65))