JVC LT-32DY8ZJ Instructions Manual page 27

Wide lcd panel tv
Table of Contents

Advertisement

Search with the "
" or "
OK. A warning message is displayed.
Start automatic search? Current PR list
will be replaced.
Yes
This starts the automatic tuning process and
searches through all the available broadcast
frequencies for free-to-air channels.
BACK
Previous channels will be replaced on auto-
matic search.
If no digital terrestrial television broadcasts
are found, the TV will display a message:
No programme found.
Please check antenna signal.
When "OK" button is pressed, following mes-
sage will appear on the right bottom side of
the screen:
PR List Empty
Manual Search:
This is for searching for digital channels on a
single broadcast frequency. The frequency
channel number (21-68) is entered in the box
at the top left of the screen and the received
signal level and signal quality can be observed
" buttons and press
No
MENU
OK
on the two bar graphs at the bottom. When OK
is pressed, the TV searches that frequency
and display a list of the channels found.
Hint
The bar graphs of signal quality and signal
level give a good indication of whether any
channels are likely to be found. If only the
signal level graph shows a high value then it
is likely that an analogue channel occupies
that broadcast frequency. If the signal qual-
ity bar is high as well then it is a digital fre-
quency and digital channels will probably
be found.
Again, channels which duplicate those already
in the channel list are ignored. However, the
manual channel search will find all channels
on the broadcast frequency.
When either search is finished, press the
MENU key to return to normal broadcast view-
ing, to watch the new digital terrestrial televi-
sion channels found.
Factory Settings:
To reset the TV, highlight the Factory Settings
line in the menu and press OK. A warning
screen is displayed in case of accidental op-
eration.
Are you sure you want to delete the PR list
and reset all settings?
Highlight the YES button with the " " or " "
key and press OK to erase all the channels
and settings. A message will be displayed on
the screen.
- 26 -
Yes
No

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents