Operation With Remote Control; Operation With The Buttons On The Tv - JVC LT-32DY8ZJ Instructions Manual

• If you turn the power switch off when the TV is
on, you can switch on the TV again by press-
ing the power switch.
Turning the TV Off
• Press the STANDBY button on the remote
control unit.
• The TV switches to standby mode and the
power lamp lights red.
• Press the power switch on the right side off
the TV.
• The TV turns off and main power lamp goes
off.
Note:
• The power switch does not fully isolate the
TV from the main power supply. To turn the
main power supply off completely, discon-
nect the power plug from the AC outlet.
You can operate your TV using both the remote
control and the buttons on the TV.

Operation with the buttons on the TV

Volume Setting
• Press " -" button to decrease volume or
" +" button to increase volume, so a vol-
ume level scale (slider) will be displayed at
the middle of the bottom on the screen.
Programme Selection
• Press " " button to select the next pro-
gramme or " " button to select the previ-
ous programme.
Switching input mode
• Pressing TV/AV button will change the input
mode.
Entering Main Menu
• Press MENU/OK button to enter Main menu.
In the Main menu select submenu using
" " or " " button and enter the sub-
menu using " -" or "
the usage of the menus, refer to the Menu
System sections.
+" button. To learn
- 17 -

Operation with Remote Control

The remote control of your TV is designed to
control all the functions of the model you se-
lected. The functions will be described in ac-
cordance with the menu system of your TV.
Functions of the menu system are described
in following sections.
Volume Setting
Press " +" button to increase volume.
Press " -" button to decrease volume.
A volume level scale (slider) will be displayed
in the middle at the bottom of the screen.
Programme Selection (Previous or next
programme)
• Press " " button to select the previous
programme.
• Press " " button to select the next
programme.
Programme Selection (direct access):
Press digit buttons on the remote control to
select programmes between 0 and 9. TV will
switch to the selected programme. To select
programmes between 10 - 99, press the digit
buttons consecutively which programme you
want to select (eg. for programme 27, first
press 2 and then 7). When it is late to press
second digit button only the first digit
programme will be displayed. The limit of the
delay time is 3 seconds.
Example: PR6 press 6, PR12
and 2.
Press directly the programme number to
reselect single digit programmes.
Hint: The channel list numbers are assigned by the broad-
casters. Because not all channels are broadcast free-to-air
and stored by the receiver, the channel list numbers do not
run continuously. The fifteenth channel in the list, for ex-
ample, may not be channel number 15 but channel number
17.
Hint: If you enter a number which does not correspond to a
stored channel, the next valid channel number is selected
instead. If you enter a number greater than the highest
numbered channel in the channel list, the DTV will select the
last channel in the list.
40
press 1