Ptz - Night Owl CM-IH8-BA User Manual

7.4.3 PTZ

Configure settings on your NVR to control a PTZ enabled camera.
Channel: Choose the channel with a PTZ enabled camera. Not all cameras are PTZ enabled.
Signal Type: Choose between Digital and Analog signals.
Protocol: Is the type of PTZ data protocol that the NVR will use to control the PTZ cameras. It is necessary to
change this only for third party PTZ Camera compatibility. The Default Value for Night Owl's PTZ camera is PelcoD.
Baudrate: Indicate the frequency of communication to the PTZ camera. We recommend leaving the default
setting which is 9600.
DataBit: Select the amount of data to send during each transmission. 8 bits is standard for all modern
data transmissions.
StopBit: Select the amount of extra data to send each time a direction is sent to the camera. The stopbit serves
as a buffer between commands and should be 1 (by default) when utilizing Night Owl's AHD PTZ camera.
Parity: Detects corrupt commands sent to and from the PTZ camera. This should generally be left disabled.
Address: Enter an ID number for the PTZ camera, greater than 0. If using multiple PTZ cameras, ID numbers
cannot be the same.
66