B) Motion Area Setup - Night Owl CM-IH8-BA User Manual

7.1.4 (b) Motion Area Setup

This system uses motion pixel sensors to detect movement. Current motion detection technology allows your
system to begin recording when a pixel change is detected by your unit. If configured, the NVR will then
send a push notification out to your Smart Device which will contain an embedded video clip of the object
triggering the motion sensors.
If there is an area within the camera's field of view that you do not want detection to be active, follow the steps below:
Click on a square in one corner of the area you don't want to be detected.
1
Drag the mouse over the area you want to block.
2
Release the mouse and verify you have selected your desired area.
3
Right click the mouse and select Save.
4
53