About The Pedal; Attaching The Stand (Sold Separately) - Roland SP-555 Owner's Manual

Appendix

About the pedal

If you connect a pedal switch (DP series; sold separately) to the rear panel PEDAL jack, you'll be able to perform the following
operations by pressing the pedal.
Function Action
REC/OVERDUB/PLAY Press the pedal to cycle through the choices,
loop capture
which are: record
Rapidly press the pedal twice to stop.
PLAY/STOP loop cap- Press the pedal to cycle through the choices,
ture
which are: play
PLAY/STOP pattern se- Press the pedal to cycle through the choices,
quencer
which are: play
Turn FIXED VELOCITY Press the pedal to toggle between on/off for
on/off FIXED VELOCITY.
Turn the effect on/off Press the pedal to turn the effect on/off.

Attaching the stand (sold separately)

68
➜ ➜ ➜
play overdub play.
➜ ➜
stop play.
➜ ➜
stop play.
Operation
While holding down [CANCEL], press the pedal
to get the display to indicate "LC.1." Press [SAMPLING] to confirm.
While holding down [CANCEL], press the pedal
to get the display to indicate "LC.2." Press [SAMPLING] to confirm.
While holding down [CANCEL], press the pedal
to get the display to indicate "SEq." Press [SAMPLING] to confirm.
While holding down [CANCEL], press the pedal
to get the display to indicate "VEL." Press [SAMPLING] to confirm.
While holding down [CANCEL], press the pedal
to get the display to indicate "EF.S." Press [SAMPLING] to confirm.
1.
Using the screws located on the bottom of the SP-555,
attach the stand holder of the PDS-10 pad stand (sold
separately) as shown in the illustration.
* You must use these screws. Using any other screws will cause
malfunctions.
When turning the unit upside-down, get a bunch of
newspapers or magazines, and place them under the four
corners or at both ends to prevent damage to the buttons and
controls. Also, you should try to orient the unit so no buttons or
controls get damaged.
When turning the unit upside-down, handle with care to avoid
dropping it, or allowing it to fall or tip over.
2.
Attach the SP-555 to the PDS-10 pad stand.
For details on assembling the pad stand or attaching the
stand holder, refer to the owner's manual of the pad
stand.
If you attach the SP-555 to the PDS-10, you must spread the
legs of the PDS-10 to their full extent. You must set up the stand
so that the total height including the SP-555 itself does not
exceed one meter.
This stand for use only with specific Roland musical
instruments. See apparatus instructions. Use with other
models is capable of resulting in instability causing possible
injury.
➜
turn the CTRL 3 knob
➜
turn the CTRL 3 knob
➜
turn the CTRL 3 knob
➜
turn the CTRL 3 knob
➜
turn the CTRL 3 knob