Changing The Signal Flow When Using Usb Audio - Roland SP-555 Owner's Manual

Connecting the SP-555 to your computer
Mac OS X users
Installing the driver
* If the "Authentication" dialog box appears during the
installation, enter the password and click [OK].
1.
Start up your computer with all USB cables
disconnected (except for a USB keyboard and/or
mouse, if used).
2.
Navigate to the "Driver" folder on the CD-ROM, and
double-click SP555USBDriver.pkg.
3.
In some cases you may see the message "A program
must be executed by this installer package to
determine whether installation is possible. Continue?"
If so, click [Continue].
4.
The screen will indicate "Welcome to the Roland SP-
555 Driver installer." Click [Continue].
5.
The screen will indicate "Select the installation
destination," so click the drive in which the system is
installed, and then click [Continue].
6.
The screen will indicate "Easy installation," so click
either [Install] or [Upgrade].
7.
The screen will indicate "When you install this
software, you'll need to restart your computer when
the installation is completed." Click [Continue with
installation].
8.
The screen will indicate "The software was installed
successfully," so click [Restart] to restart your
computer.
This completes installation of the SP-555 Driver.
Installing SP-555 Wave Converter
1.
Navigate to the "Wave Converter" folder on the SP-
555 UTILITY CD-ROM, and double-click "SP-555 Wave
Converter Installer.pkg."
2.
The installer will start up. Follow the on-screen
instructions to proceed with installing SP-555 Wave
Converter.
This completes installation of SP-555 Wave Converter.
42
Changing the signal flow
when using USB audio
For the default state and the overall signal flow, refer to
"Signal flow (block diagram)" (p. 14).
To do this Operation
Turn the USB audio Hold down [CAN-
input on/off from CEL] and use the
your computer CTRL 3 knob ("oFF"
/ "on")
Apply or bypass the While holding down
effect for the USB au- [EFFECT ASSIGN]
dio input from the and [CANCEL],
computer press [MIC (or [LINE
IN])
Switch the source While holding down
that is output to USB [CANCEL], press
audio from the SP- [LINE IN] and use
555 the CTRL 3 knob
("oFF" / "InP" /
"out")
If you're using software that has a recording monitor or input
monitor function, and select "InP" as the source being output
from the SP-555 to USB, it is possible that the audio signal will
create a feedback loop. Either turn off the recording monitor
or input monitor function in your software, or select "OFF" or
"out" for the source being output from the SP-555 to USB
audio.
Remarks
Default setting is on.
This setting will re-
turn to the default
when you turn off
the power.
The effect is applied
by default. This set-
ting will return to the
default when you
turn off the power.
The default setting is
out (output the same
signal as LINE
OUT). InP will output
only the LINE IN sig-
nal and MIC IN sig-
nal. This setting will
return to the default
when you turn off
the power.