Before You Begin Playing; Setting Up For Performing; Attaching The Music Rest; Using The Music Holders - Roland HPi-6 Owner's Manual

Before You Begin Playing

Setting Up for Performing

■ Attaching the Music Rest

The music rest of the HPi-6 contains a liquid crystal display screen.
Use the following procedure, and handle the music rest with care.
1.
Secure the music rest in place by turning the included
screws (at two points).
When attaching the music rest, support it firmly with one hand
to make sure that you don't drop it. Be careful, so you don't get
your fingers pinched.
fig.MusicRest
Screw
2.
Connect the LCD cord of the music rest to the LCD Out
connector on the rear panel of the HPi-6.
NOTE
The power must be off when connecting the cable of the music rest.
fig.LCDCord-e

■ Using the Music Holders

You can use the holders to hold pages in place.
When not using the holders, leave them folded down.
fig.MusicHolders
View from Rear
Screw
LCD Cord

■ Connecting the Pedal Cord

1.
Insert the end of the pedal cord extending from the
piano stand to the Pedal jack located at the lower part
of the HPi-6's rear panel.
fig.PedalCord
Pedal Cord

■ Connecting the Power Cord

1.
Insert the included power cord into the AC inlet
located on the rear bottom of the HPi-6, then plug the
other end of the cord into a AC outlet.
NOTE
Use only the included power cord.
fig.ACCord-e
AC In
AC Outlet
Power Cord
17