Before You Play; Getting Ready To Play; Connecting The Pedal Cord; Connecting The Power Cord - Roland HP-203 Owner's Manual

Before You Play

Getting Ready to Play

Connecting the Pedal Cord

Plug the pedal cord extending from the stand into the Pedal
connector located at the back of the HP203's bottom panel.
fig.PedalCord.eps
16

Connecting the Power Cord

1.
Make sure that the [Power] switch located at
the left side of the front panel is off (in the
upward position).
fig.PowerOff-e.eps
Upward
position
OFF
2.
Turn the [Volume] knob all the way toward the
left to minimize the volume.
3.
Connect the included power cord to the AC
INLET located at the rear of the bottom panel.
4.
Plug the other end of the power cord into an
AC outlet.
fig.PowerCord.eps
3
You must use the power cord included with the
NOTE
HP203.
4