Roland Fantom-X6 Owner's Manual page 273

08: AUTO WAH
Cyclically controls a filter to create cyclic change in timbre.
fig.MFX-08
L in
Auto Wah 2-Band EQ
R in
Auto Wah 2-Band EQ
Parameter Value
Filter Type LPF, BPF
Manual # 0–127
Peak 0–127
Sens # 0–127
Polarity UP, DOWN
Rate # 0.05–10.00 Hz,
note
Depth # 0–127
Phase # 0–180 deg
Low Gain -15– +15 dB
High Gain -15– +15 dB
Level 0–127
09: HUMANIZER
Adds a vowel character to the sound, making it similar to a human
voice.
fig.MFX-09
L in
Overdrive
R in
Parameter Value
Drive Sw OFF, ON
Drive # 0–127
Vowel1 a, e, i, o, u
Vowel2 a, e, i, o, u
Rate # 0.05–10.00 Hz,
note
Depth # 0–127
Input Sync OFF, ON
Sw
Input Sync 0–127
Threshold
Manual # 0–100
Low Gain -15– +15 dB
High Gain -15– +15 dB
Pan # L64–63R
Level 0–127
L out
R out
Description
Type of filter
LPF: The wah effect will be applied
over a wide frequency range.
BPF: The wah effect will be applied
over a narrow frequency range.
Adjusts the center frequency at which
the effect is applied.
Adjusts the amount of the wah effect
that will occur in the range of the center
frequency.
Set a higher value for Q to narrow
the range to be affected.
Adjusts the sensitivity with which the
filter is controlled.
Sets the direction in which the frequen-
cy will change when the auto-wah filter
is modulated.
UP: The filter will change toward a
higher frequency.
DOWN: The filter will change to-
ward a lower frequency.
Frequency of modulation
Depth of modulation
Adjusts the degree of phase shift of the
left and right sounds when the wah ef-
fect is applied.
Gain of the low range
Gain of the high range
Output Level
Pan L
2-Band
Formant
EQ
Pan R
Description
Turns Drive on/off.
Degree of distortion
Also changes the volume.
Selects the vowel.
Frequency at which the two vowels
switch
Effect depth
Determines whether the LFO for
switching the vowels is reset by the in-
put signal (ON) or not (OFF).
Volume level at which reset is applied
Point at which Vowel 1/2 switch
49 or less: Vowel 1 will have a long-
er duration.
50: Vowel 1 and 2 will be of equal
duration.
51 or more: Vowel 2 will have a
longer duration.
Gain of the low frequency range
Gain of the high frequency range
Stereo location of the output
Output level
10: SPEAKER SIMULATOR
Simulates the speaker type and mic settings used to record the
speaker sound.
fig.MFX-10
L in
R in
Parameter
Speaker Type
Mic Setting
Mic Level #
Direct Level #
Level #
Specifications of each Speaker Type
The speaker column indicates the diameter of each speaker unit (in
inches) and the number of units.
Type
SMALL 1
SMALL 2
MIDDLE
JC-120
BUILT-IN 1
BUILT-IN 2
BUILT-IN 3
BUILT-IN 4
BUILT-IN 5
BG STACK 1
BG STACK 2
MS STACK 1
MS STACK 2
METAL STACK
L out
2-STACK
3-STACK
R out
L out
Speaker
R out
Speaker
Value Description
(See the table right.) Type of speaker
1, 2, 3 Adjusts the location of the mic
that is recording the sound of
the speaker.
This can be adjusted in
three steps, with the mic
becoming more distant in
the order of 1, 2, and 3.
0–127 Volume of the microphone
0–127 Volume of the direct sound
0–127 Output Level
Cabinet Speaker
small open-back enclosure 10
small open-back enclosure 10
open back enclosure 12 x 1
open back enclosure 12 x 2
open back enclosure 12 x 2
open back enclosure 12 x 2
open back enclosure 12 x 2
open back enclosure 12 x 2
open back enclosure 12 x 2
sealed enclosure 12 x 2
large sealed enclosure 12 x 2
large sealed enclosure 12 x 4
large sealed enclosure 12 x 4
large double stack 12 x 4
large double stack 12 x 4
large triple stack 12 x 4
Effects List
Micro-
phone
dynamic
dynamic
dynamic
dynamic
dynamic
condenser
condenser
condenser
condenser
condenser
condenser
condenser
condenser
condenser
condenser
condenser
273