Roland CD-2e Owner's Manual page 37

6
Adjust the input level of the internal mics.
On the CD-2e's left side, set the [MIC LEVEL] switch to its "MANUAL" position.
fig.rec-intmic02.eps
Turn the [MIC] knob to adjust the input level of the internal mics.
Adjust the loudness of the sound you're recording. Since you're not using the line input, turn
the [LINE] knob all the way to the left (off).
While producing the sound that you'll actually be recording, turn the [MIC] knob to adjust the
input level.
Adjust the level so that the peak indicator located above the [MIC] knob lights briefly at the
loudest moments of the performance or vocal you'll be recording.
fig.rec-intmic03-e.eps
Quieter Louder
Peak indicator
If the input level is high
●
The peak indicator will light to indicate that the audio input has exceeded this limit (i.e.,
the input is too loud). If you record even though the peak indicator is lit, the recorded
audio will be distorted.
If the input level is too low
●
will not be as loud as it should be.
7
Press the [ (Record)] button to enter recording-standby mode.
fig.rec-intmic04-e.eps
8
Press the [
Start your performance.
fig.rec-intmic05-e.eps
Recording Acoustic Instruments or Vocals
At this position
The input level and the recorded result
There is a limit on the level that the CD-2e is able to record.
The recorded audio will not be distorted, but the playback
Blinking
(Play)] button to begin recording.
Lit
The level meter will move according
to the level of the audio input.
Remote control
Remote control
(continued)
37