Preparing The Remote Control; Installing Batteries In The Remote Control; Using The Remote Control - Roland CD-2e Owner's Manual

Preparing the Remote Control

Installing Batteries in the Remote Control

Install a coin-type lithium battery (included) in the remote control.
fig.remote01-e.eps
1
Back side of the
remote control
* Use only the specified type (model no.CR2025) of lithium battery. Be sure to insert it as
directed to ensure correct polarity.
1
Pull out the battery holder.
2
Insert a lithium battery (CR2025) as shown in the illustration.
3
Replace the battery holder.
Push it inward until it clicks into place.

Using the Remote Control

Point the remote control toward the CD-2e's sensor, and operate it within the specified
operating range.
When the remote sensor detects a remote control operation, the [ENTER] button will
blink.
fig.remote02-e.eps
* Even if the remote control is within range, it may not work if there is an obstruction between it
and the remote sensor, or if the angle is excessive.
* The battery life will depend on the conditions of use. When the battery runs down, the operating
angle will become narrower. Replace the battery if this occurs.
* If you won't be using the remote control for an extended period of time, remove the battery.
* If a spotlight or other strong light is directed at the remote sensor, it will be less responsive.
Press here in the direction of the
arrow while you pull out the holder.
Battery holder
Remote sensor
Transmitter
2
Remote control operating range
Distance: 5 meters
Angle: 45 degrees or less
Batteries to use:
Lithium battery
(CR2025)
29