Roland CD-2e Owner's Manual page 23

Turning the power off
1
On the CD-2e's rear panel, set the [POWER] switch to the "OFF" position.
Remaining battery indicator
If you're operating the CD-2e on batteries, the battery indicator will be shown on the
screen.
If you continue use the CD-2e when the batteries are low, the display will indicate
"Battery Low," and eventually the power will turn off.
fig.icon-battery-e.eps
Battery life
Continuous use
* The battery life given here is only an approximation. It will vary depending on the frequency and
conditions of use.
Note
You must turn off the power before performing the following operations.
● Switching from operation with the dedicated AC adaptor to battery operation
● Switching from battery operation to operation with the dedicated AC adaptor
Important
● If you want to use batteries, disconnect the dedicated AC adaptor. The batteries will not
be used as the power supply if the dedicated AC adaptor is connected.
● Don't mix new batteries with partially-used batteries, and don't mix batteries of differing
types.
● If you won't be using the CD-2e for an extended period of time, remove the batteries to
prevent possible leaking damage.
Turning the Power On and Off
Sufficient capacity remaining.
Batteries are running low.
Batteries are almost empty.
Replace the batteries.
* The remaining battery indicator is only an approximation.
Approximately 6 hours
(continued)
23