Group Access - Supermicro SSE-G24-TG4 Configuration Manual

SNMP Configuration Guide

1.6.6 Group Access

Group access defines the access policy for a set of users belonging to a particular group. Group access is
used only for SNMPv3.
Follow the steps below to configure SNMP group access.
Step Command
Step 1 configure terminal
Step 2
snmp access <GroupName> {v1 | v2c | v3 {auth |
noauth | priv}} [read <ReadView | none>] [write
<WriteView | none>] [notify <NotifyView |
none>] [{volatile | nonvolatile}]
Step 3 end
Step 4 show snmp group access
Description
Enters the configuration mode
Configures the SNMP group access.
GroupName - Alphanumeric value with
a maximum of 40 characters.
Security model – Mention one of v1,
v2c or v3.
Use auth to enable authentication for
the user.
Use priv to enable encryption of
packets.
ReadView- View name that specifies
read access to particular MIB sub-tree.
Alphanumeric value with a maximum of
40 characters.
WriteView View name that specifies
write access to particular MIB sub-tree.
Alphanumeric value with a maximum of
40 characters.
NotifyView View name that specifies a
particular
notification. Alphanumeric value with a
maximum of 40 characters.
Use volatile if the value need not be
stored in NVRAM.
Use nonvolatile if the value must be
stored in NVRAM and available after
restart.
Exits the configuration mode.
Displays the SNMP group access
information.
Supermicro L2/L3 Switches Configuration Guide
MIB sub-tree used
19
in