Snmp Notify - Supermicro SSE-G24-TG4 Configuration Manual

SNMP Configuration Guide
SMIS(config)# snmp targetparams param4 user user4 security-model v2c message-processing v2c
SMIS# end
SMIS# show snmp targetparam
Target Parameter Name: Internet
Message Processing Model: v2c
Security Model: v2c
Security Name: None
Security Level: No Authenitcation, No Privacy
Storage Type: Volatile
Row Status: Active
------------------------------
Target Parameter Name: param4
Message Processing Model: v2c
Security Model: v2c
Security Name: user4
Security Level: No Authenitcation, No Privacy
Storage Type: Volatile
Row Status: Active
------------------------------
Target Parameter Name: test1
Message Processing Model: v2c
Security Model: v1
Security Name: None
Security Level: No Authenitcation, No Privacy
Storage Type: Volatile
Row Status: Active
------------------------------

1.7.3 SNMP Notify

Notify is used to specify the type of notifications to be sent to particular targets that are grouped under
a particular tag.
Follow the steps below to configure the SNMP Notification.
Step Command
Step 1 configure terminal
Step 2 snmp notify <NotifyName> tag <TagName> type
{Trap | Inform} [{volatile | nonvolatile}]
Description
Enters the configuration mode
Configures
information.
NotifyName - Alphanumeric value with
a maximum of 40 characters.
n
TagName –Specifies a group of targets
identified by this name. Alphanumeric
Supermicro L2/L3 Switches Configuration Guide
the SNMP Notify
24