Installation - Mira Elite QT Installation & User Manual

Installation

Plumbing
1. The plumbing installation must comply with all national or local water regulations and
all relevant building regulations, or any particular regulation or practice specified by
the local water supply company.
2. The shower is designed to operate with a gravity fed water supply providing a pressure
from 0.8 kPa* (0.008 bar / 80 millimetres head) to 100 kPa (1 bar / 10 metres head,
the vertical distance from the base of the cold water cistern to the top of the shower
unit). The shower must have its own separate supply from the cistern.
DO NOT FIT THE SHOWER TO A MAINS WATER SUPPLY OR WHERE THE
MAXIMUM SPECIFIED PRESSURE MAY BE EXCEEDED!
Failure to comply with these restrictions may result in product damage not covered
by the guarantee.
* Note! In practice the minimum head required will increase with pipe length. See
"Pipework" for further guidance which includes a calculation table to make sure that
adequate head is available for any given installation.
Incorrect Cistern Take Off
Debris from the bottom of the
cistern and air generated when
the cistern refills will enter the
shower supply.
3. DO NOT install the product in a position or location that will
limit access for servicing.
4. A suitable position for the shower will have a minimum clear
distance of 200 mm above and below the shower unit to
allow for cover removal and refitting.
5. The position of the shower and shower fittings must provide
a minimum air gap of 25 mm between the showerhead
and the spill over level of any bath, shower tray or basin.
There must be a minimum distance of 30 mm between the
25 mm
To shower
unit only.
7
25 Gallon/113 Ltr Cistern
Correct Cistern Take Off
Positioned away from the ball
valve, with a 25 mm distance
from the base of the cistern.
This connection will prevent
air and debris entering the
shower supply.
1265606-W2-A
200 mm
200 mm