User Maintenance - Mira Elite QT Installation & User Manual

User Maintenance

WARNING! PLEASE OBSERVE THE FOLLOWING TO REDUCE
THE RISK OF FIRE, ELECTRIC SHOCK, INJURY OR PRODUCT
DAMAGE:
■ No user serviceable parts can be accessed by removing the cover.
Mains connections are exposed when the cover is removed. Only
qualified, competent personnel should remove the cover.
■ Isolate the electricity to the shower unit before cleaning or
performing any user maintenance.
■ DO NOT allow children to clean or perform any user maintenance
to the shower unit without supervision.
■ DO NOT use the showerhead to clean the shower unit.
■ If the shower is not to be used for a long period, the electrical
supply and water supply to the shower unit should be isolated.
If the shower unit or pipework is at risk of freezing during this
period, a qualified, competent person should drain them of water.
Cleaning / Replacing Filter
The filter can be safely removed from the lower left of the shower unit. Isolate the electrical
supply to the shower unit before removing the filter. The water supply will shut off automatically
as the filter is removed, however we recommend isolating the water supply to the shower unit
to aid with refitting the filter.
1
Insert a suitable coin or an 8 mm hexagonal
key into the cap and turn to the left.
Cleaning
Many household cleaners contain abrasives and chemical substances, and should not be used
for cleaning plated or plastic fittings. These finishes should be cleaned with a mild washing
up detergent or soap solution, and then wiped dry using a soft cloth.
1265606-W2-A
2
Rinse the filter in clean warm water removing
any dirt or debris. Replace if the filter mesh
is damaged. Make sure the filter is correctly
refitted to the locked position.
22
Locked
position