Page 2
Troubleshooting HC SUPPORT Thank you for purchasing the Hunter HC Expansion Module. In this Quick Start Guide you will learn how to install and configure the HC Expansion Module. For support for Hydrawise™ cloud software or help with your Hydrawise account, please visit hunter.direct/hchelp.
INSTALLATION Expansion Module Location The Hydrawise Expansion Module is designed for installation in a protected location. The chosen location for the expansion module should be within 20in (500mm) of the main controller. Cable Entry The Expansion Module has 2 cable entry options – from the rear of the case or via a conduit from the bottom of the Expansion Module.
Page 4
Mounting The Expansion Module 1. Using a drill bit of 3/ 16 inch diameter, drill 4. Slide the controller case over the a hole to a depth of 1 inch (25 mm). screw head. 2. Insert plastic anchor so it is flush with 5.
Your expansion module has 12 zones. If you have a master valve, it must be connected to the master controller. Refer to your HC Controller Quick start guide or hunter.direct/hchelp for wiring instructions. Connecting The Expansion Module To The Master Controller Power for the Expansion Module is supplied by the master controller via a cable between the units.
Connecting The Expansion Module Power for the Expansion Module is supplied by the master controller via a cable between the units. Note that only the 12 zone controller supports expansion modules. 1. Using the cable supplied, connect the Master Note: You must use the Controller and Expansion Module.
Page 7
HYDRAWISE APP CONFIGURATION Your Hydrawise controller needs to be configured for the new expansion module. Once you have added an expansion module to your controller you will be able to configure extra zones. Log Into Your Hydrawise Account 1. Log into your account as you did when first registering your controller. Add Your Expansion Module To Your Controller’s Configuration 2.
Detailed instructions can be found on the Hydrawise website. • Check that your wiring is correct. If no solenoids start then check that your COMMON wire is correctly wired. Find more helpful information on your product? Find tips on installation, controller programming and more... hunter.direct/hchelp LIT-694-QS-EM US 10/16...