Checking The Neutral Switch Operation (Ehd); Checking The Choke Solenoid Position (Ed, Et) - Yamaha 55DEHD Service Manual

5. Adjust the position of the shift cable joint
3 until its hole is aligned with the set pin
c.
3
c
w
The shift cable joint 3 must be screwed in
a minimum of 8.0 mm (0.31 in) c.
NOTE:
Pull the shift cable toward the engine to
remove any free play in the shift cable before
adjusting the position of the cable joint.
6. Connect the shift cable joint, install the
clip.
7. Check the gear shift for smooth opera-
tion, check the neutral switch operation. If
necessary, repeat the steps 3–6.
Checking the neutral switch opera-
tion (EHD)
w
Remove the all spark plug caps from all
cylinder, while checking the neutral
switch.
6885J11
1. Check that the neutral switch 1 is
pushed by the shift lever 2, when the
gear shift is in the "N" position.
68830355
2. Set the gear shift to "F" or "R" position.
3. Check that the starter motor can not
operate, when turning the engine start
switch to "START".
NOTE:
To check the neutral switch continuity, refer to
page 8-11.
Checking the choke solenoid posi-
tion (ED, ET)
1. Set the choke knob to fully closed posi-
tion.
2. Check the plunger to align the mark a
with the solenoid surface b.
R
N
b
a
Control system
1
F
2
2
1
68830360
3
4
5
6
7
8
68830370
9
3-14