Enabling And Disabling Securemode - Siemens F IWLAN Operating Instructions Manual

Configuring the HMI device
6.1 Desktop and Loader
Loader
The following figure shows the Loader.
The buttons on the Loader have the following function:
● "Transfer" button – This switches the HMI device to "Transfer" mode.
The transfer mode can only be activated when at least one data channel has been
enabled for the transfer.
● "Start" button – This starts the project on the HMI device.
When you do not perform any operation, the project starts automatically based on the
settings in the Control Panel after a delay time.
● "Control Panel" button – This opens the Control Panel.
You can make a variety of settings in the Control Panel, for example, the settings for the
transfer.
● "Taskbar" button – This opens the taskbar and the Windows CE Start menu.
The Loader will reappear when the project is closed on the HMI device.
Password protection
You can protect the Control Panel and taskbar from unauthorized access.
If password protection is configured, the "secure mode" message is displayed on the
desktop. If the password is not entered, only the "Transfer" and "Start" buttons are operable.
You can find additional information on Secure Mode in the section "Enabling and disabling
SecureMode (Page 101)."
NOTICE
Keeping the password
If the password is no longer available, you are forced to update the operating system to
regain access to the Control Panel and the Windows CE taskbar.
Backup password to protect it against loss. You can find additional information on updating
the operating system in the section "Updating the operating system (Page 191)."
98
PRELIMINARY II
Wireless Teach Pendant F IWLAN V2
Operating Instructions, 08/2010, A5E02453837-01
1.7.2010