Siemens AOP Operating Instructions Manual page 29

The user will then be presented with a text screen with the first character
highlighted by the cursor. The text string can contain a maximum of 20
characters.
1. Using the
desired character is shown.
2. Press the
character.
3. Repeat steps 1 and 2 until the desired text is entered.
4. Press and hold the
the Setup menu
Pressing and holding down the
original text string and return the user to the Setup menu.
Pressing the
the relevant help screens to assist the user.
7.1.7 Parameter Set Names
This function allows the user to edit the parameter set names. All ten parameter
sets can be edited. This option is not available in the standard access level.
To edit the parameter set names, the following procedure should be performed:
1. Using the
option from the Setup menu.
2. Press the
The user is then presented with the Parameter Set Names screen.
3. Using the
4. Press the
The text string of the parameter set name is then edited using the same
procedure as given in Section 8.1.5.
Pressing and holding down the
original text string and return the user to the Setup menu.
Pressing the
the relevant help screens to assist the user.
AOP Operating Instructions – Issue 07/05
6SE6400-5AP00-0BB0
and keys scroll through the characters until the
key to accept the character and move to the next
key to except the text string and return to
key will cancel the text entry, restore the
and keys simultaneously, at any time will display
and keys select the 'Parameter Set Names'
key to confirm.
and keys select the required parameter set.
key to confirm the parameter set.
key will cancel the text entry, restore the
and keys simultaneously, at any time will display
29