Table of Contents
Advertisement
The access level is set through parameter P0003. The following values can be
set using P0003:
P0003 = 0 User Defined List
P0003 = 1 Standard Parameters
P0003 = 2 Extended Parameters
P0003 = 3 Expert Parameters
P0003 = 4 Service Level
All parameters that are changed using the methods outlined below are changing
the physical parameters on the inverter connected to the AOP.
1.
From the Main Menu scroll through the list of options using
the
2.
Press the
The user is then presented with the parameter screen from which they can
select the required parameter group.
3.
Using the
desired parameter group.
Once a group is selected the user will be presented with the first parameter in
ascending order of numerical value.
4.
Using the
required parameter is highlighted.
5.
Press the
6.
The user is now presented with parameter values.
Using the
changed.
Note
The AOP will only accept values for the parameter within a pre-
defined range. An out of range value will be rejected and the
user requested to enter a correct value.
7.
Press the
The user is then returned to the parameter screen, ready to select another
parameter if required.
A long press of the
parameter value that has been changed will be retained within the AOPs internal
memory, but not sent to the inverter. Should power to the inverter or AOP be
disconnected, all changes will be lost.
AOP Operating Instructions – Issue 07/05
6SE6400-5AP00-0BB0
and
keys until 'PARAMETERS' is highlighted.
key to confirm the selected option.
and
keys scroll through the groups and select the
and
keys scroll through the parameters until the
key to confirm the selected parameter.
and
keys the value of the parameter can be
key to accept the new value of the parameter.
key will return the user to the previous screen. The
23
Hide quick links:
Advertisement
Table of Contents
