Aop Start-Up; Power On And Initialization; Language Selection - Siemens AOP Operating Instructions Manual

3

AOP Start-Up

3.1

Power On and Initialization

On Power-up the AOP will display the welcome screen.
Once the AOP to inverter communications has been established the welcome
screen is replaced by one of the following:
Language selection menu (only at first power-up or after a reset).
Start help page (start help is ON).
Normal operation display (start help is OFF).
Display type depends on the operating mode in use.
3.2

Language Selection

The AOP has the ability to display information in a number of languages.
Notes
Prior to language selection the AOP has no control over the
inverter.
Memory Limitation
The delivered AOP supports five European Languages of English,
German, French, Spanish and Italian. Due to internal memory
limitations the user should delete one of these languages in
order to upread the specified ten parameter sets that can be
held on the AOP.
To Delete a Language
Select "Language" from the top level menu, highlight the language
you want to delete then press "Fn" and "↑". Please note that
once a Language has been removed it cannot be restored.
Language selection is performed with the AOP on-line and connected to the
inverter. After powering-up and the AOPs internal self-test has been performed,
the user will be prompted to select a language:
AOP Operating Instructions – Issue 07/05
6SE6400-5AP00-0BB0
15