Crestron HR-310 Installation Manual

DO
HR-310/HR-310-I
Handheld Remote
DO Install the Battery Pack
The Crestron ® HR-310 and HR-310-I ship with three AAA alkaline batteries that must be installed
prior to operating the remote. Use the following procedure to install the battery pack.
NOTE: The HR-310 and HR-310-I are functionally similar. For simplicity within this guide, the term
"remote" is used except where noted.
1. Locate the battery cover on the rear of the remote. Gently push on the battery cover while
sliding it down and away from the remote until the tabs connecting the cover to the remote
disengage.
2. Install the included AAA batteries as shown in the illustration following step 3. Observe the
correct polarity when inserting the batteries into the compartment.
3. Reattach the battery cover by aligning the tabs on the top and bottom of the cover with
their respective slots on the bottom of the remote, and then gently slide the cover upward
until the tabs snap into place.
Battery cover
DO Acquire the Remote
The remote must be acquired by an infiNET EX
built-in infiNET EX gateway (both not included) before it can be used with a Crestron control
system. Supported devices with infiNET EX gateways currently include the Crestron CEN-GWEXER,
DIN-AP3MEX, and MC3. Use the procedures outlined in this section to join or leave an infiNET EX
network and to verify communications between the device and the control system.
GUIDE
AAA batteries (3): HR-310/HR-310-I
positive (+) terminals (rear view)
® wireless gateway or by a control system with a
DO Check the Box
QTY PRODUCT
1 Batteries, AAA Alkaline, x3
Joining an infiNET EX Network
1. Press the ACQUIRE button on the infiNET EX gateway to enter Acquire mode, or enter
Acquire mode from Crestron Toolbox™ software. For more information, refer to the
CEN-GWEXER Installation Guide (Doc. 7723), the DIN-AP3MEX Installation Guide
(Doc. 7492), or the MC3 DO Guide (Doc. 7774) at www.crestron.com/manuals.
NOTE: In an environment where there are multiple gateways installed, only one gateway
should be placed in Acquire mode at any time.
2. Quickly press the (Home) button on the remote three times, and then press and hold
the button (press, press, press, press + hold) until the 5-way navigation pad backlight
on the remote flashes once. (This process can take up to 10 seconds.)
3. Release the button to start the acquire process. The navigation pad backlight flashes
slowly to show that the remote is actively scanning the infiNET EX network.
4. Confirm the status of the acquire process:
• If the remote is acquired by the infiNET EX network, the navigation pad backlight turns
on for five seconds.
• If the remote is not acquired by the infiNET EX network, the navigation pad backlight
rapidly flashes. Press the
is in Acquire mode and that the remote is in range before attempting the acquire
process again.
5. After the acquire process is complete, remove the gateway from Acquire mode as
described by the gateway's documentation.
NOTE: Firmware updates can only be performed by connecting the remote to Crestron Toolbox
via USB. Remove the battery cover on the rear of the remote to locate the micro USB port, and then
connect the remote to the computer using a micro USB to USB A cable (not included). For more
information on performing firmware updates in Crestron Toolbox, refer to the embedded Crestron
Toolbox help file.
Leaving an infiNET EX Network
To leave an infiNET EX network, put the remote into Acquire mode as described in "Joining an infiNET
EX Network" when no gateway has been placed in Acquire mode.
PART NUM.
2022558
button to cancel the acquire process. Ensure the gateway