Belt Or Brushroll: Removal & Replacement - Dirt Devil M084650RED Owner's Manual

BELT OR BRUSHROLL: REMOVAL & REPLACEMENT
TOOL REQUIRED: PHILLIPS SCREWDRIVER
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE CHANGING BELT OR
BRUSHROLL.
BELT STYLE
For Belt Style 15 replacements, please visit our website at www.dirtdevil.com to buy
15
online or call customer service at 1-800-321-1134.
TO REMOVE BELT
1. 2.
Lay cleaner flat and flip cleaner to Tilt rollers up and away from
expose nozzle base. Base should lay the base of the cleaner as you
remove the nozzle guard. Grasp
flat and face up. To remove nozzle
nozzle guard in the middle of
guard, use Phillips screwdriver to
the brushroll area and pull up
remove the five (5) screws. Arrows
and away from base for easier
show location of screws.
removal.
TO REPLACE BELT OR BRUSHROLL
4. 5.
Lift and remove brushroll. Dispose Slide belt onto motor shaft.
of old belt.
7.
7a.
With new belt in place, pull and slide Reattach nozzle guard by
brushroll into nozzle making sure that carefully sliding back into
the brushroll end caps are in the correct place. Interlock rollers and
orientation (7a inset). Rotate brushroll nozzle guard by tilting rollers
manually to make sure belt is properly down towards the base while
aligned. replacing the nozzle guard.
3.
MOTOR
Slide belt off motor shaft.
6.
Place new belt in area of
brushroll without bristles.
8. 9.
Be sure to replace all five (5)
screws.
8
SHAFT